GrowerSELECT® Installation Manuals Binder

Hog Slat Inc. Newton Grove, NC USA May 2017 15 GROW-DISK ™ Feed System GROW-DISK™ Corner Assembly Requirements The GROW-DISK™ Corners must be assembled in such a way that it meets all the following conditions. • The corners must be assembled so that the arrow on the guide wheel turns in the direction of transportation . Note: Mark the chain running direction at the conveyer tubes in front or behind of each corner. • Conveyer tubes must be inserted into the corner up to the tube stop. • Conveyer tubes must be supported in front of and behind each corner. • Distance between the corners must be at least 4 feet. • Distance between the input side of drive unit to corner must be a minimum of 8 feet. • Distance between the output side of drive unit to corner must be a minimum of 4 feet. • Maximum 24 corners per system. Installation and Sealing of Corners (WL10222096) Tube Stop Location Tube Stop 1. Open the pre-assembled corner and remove the fastener kit. Place the corner between the installed conveyor tubes (tubes must be straight cut and clean). Insert both tubes 3.23” (82mm) into the corner as shown above. Note: Tubes must bottom out against tube stop as shown above on right. 2. Attach the blue clamp straps over the conveyer tubes with 2 bolts and nuts per strap. Important: Confirm position of wheel has gap as shown above on right. 3.23” 82mm