GrowerSELECT® Installation Manuals Binder

Hog Slat Inc. Newton Grove, NC USA May 2017 23 GROW-DISK ™ Feed System 3. Snap the Shutoff Assembly with Cord on the metal tubing of previously drilled or cut Outlet Hole. 4. Assemble (snap) the Outlet Adapter onto the metal tubing under the Shutoff Assembly over the Outlet Hole. Outlet Adapter should remain in place. 5. Tie a knot in center of cord and position knot into Shutoff Assembly as shown below. Place cord in slots of Outlet Adapter. Assemble Cover to top of Outlet Adapter over Shutoff Assy. 6. Assemble supplied Clamps on each end of Outlet Assembly as shown to prevent sliding and rotation. Make sure the entire Outlet Drop is centered over the Outlet Hole. Adjust Outlet drop for proper downward orientation and tighten Clamps to hold in place. Note: Make sure that Cords are still in guide slots and move freely prior to tightening Clamps. 7. Determine the appropriate length of Cord needed to ensure greatest ease of actuation. Assemble Indicator Balls on the Cord ends and knot each end of Cord so the Indicator Balls will not pull off. Green Indicator Ball should be assembled to end of Cord closest to retainer pocket of Shutoff or the “Open” position. Check by looking up through the Adapter opening. Check for proper function by using Indicator Balls to open and close Outlet Drop. Cord in Adapter Slots Clamps