GrowerSELECT® Installation Manuals Binder

Hog Slat Inc. Newton Grove, NC USA May 2017 37 GROW-DISK ™ Feed System Drive Unit Chain Safety Switch and Door Switch Each Drive unit is equipped with 2 safety switches. The door switch prevents the system from starting with cover off or shuts it down if the cover would be removed during operation. The chain safety switch will shut off the system if the conveyer chain tension is too loose or conveyer chain is blocked. Drive Unit Chain Safety Switch The safety switch is located inside the Drive Unit as shown below. The switch can be activated in either direction by a bracket which is attached to the idler wheel. If either side of the bracket (caused by chain being too long or too short) comes in contact with the limit switch, it will shut the system down. It will also shut down if the chain or spring breaks or if a foreign object gets hung in system. Disconnect power and locate problem before attempting to reactivate the system. Once the problem has been corrected, pull the blue reset button on the safety switch and reset the HSCD-100 Controller. Position of Safety Switch should be installed approximately 2” from left side of bracket as shown above. Chain Safety Switch Door Switch Pull blue button to reset switch